Hot Bodies, under the Moorespeed label, have released this new 908 bodyshell, which has been designed for 1/12th scale circuit racing. This totally new design was developed from the ground up to be the ideal bodyshell for a wide range of racers and tracks. The air rushing over the bodyshell starts at the ground-level splitter and is forced over the front wheels and around the closed cockpit by sculpted flow channels. Ridges over the front wheels disrupt the air just enough to break it loose over the wheel arches until it flows back down slightly over the middle section of the body. The closed cockpit area helps stabilize the air as it rushes over the midsection, which hugs the battery and electronics area of the car chassis as closely as possible. As the air meets the rear wheels, further ducting and vertical supports direct the air over the rear spoiler, where a huge amount of downforce is created. Molded from crystal clear polycarbonate, it features clear overspray film, a pre-cut vinyl window mask sheet, and a decal sheet with headlights and Hot Bodies logos. Also available in lightweight version.

Continue Reading…

Hot Bodies have released lots of new products for their European Championship winning Cyclone 12, starting with 3 new shells. These shells offer different tuning possibilities for the C12 and are available as an open cockpit shell, the Mark-I, as well as 2 closed cockpit versions called the Mark-II and III. Also available for further tuning your chassis are 2 new ranges of spring hardnesses, soft and hard, for both the front and rear of the car as well as new 4mm trailing offset front wheel axles, giving the car a different steering response compared to the 2mm trailing offset that comes with the kit. Finally for the C12, is a new shock shaft, front kingpins and wishbone pivot pins, that have been titanium nitrade coated for a smoother action that the standard steel parts.

Continue Reading…

We only briefly mentioned the new EU Moore-Speed Reynard 02S 1/12th scale body in one of our Daily round ups last week, because we had written about it back in February, but today we see that the body will actually be available in 2 different versions, normal and lightweight. Designed for high cornering speeds, this body shell features a sculpted front end and mid section to direct air over the gentle curves of this single-focus body shell giving you superb high speed stability and performance on the straight. Moulded from crystal clear polycarbonate, it features clear over spray film and a decal sheet with headlights and Hot Bodies logos.

Source: Hot Bodies [hbeurope.com]